How do I reset the BIOS on my Relio R1 embedded computer when I cannot see the display?

To reset the the BIOS of the Relio R1 Embedded Computer, follow these steps:

1. Attach a USB keyboard to the computer.
2. Apply power and immediately press and hold the Delete key for 15 seconds. This will ensure the computer has had time to boot and enter the BIOS.
3. Press the F9 key to load Optimal Defaults. Then, press the Enter key to validate the change.
4. Press the F10 key to save and exit the BIOS. Then, press the Enter key to validate the change.
5. If performed properly, the DDI1 setting will have been restored to DisplayPort, the BIOS settings were saved to flash memory, and the computer was rebooted. The display should now be working. If this does not work, contact Sealevel Systems Technical support.
6. Once the computer has rebooted and video is working, it is a good idea to disable the LVDS flat panel interface. It was enabled by restoring “Optimal Defaults” in step 3.
7. Enter the BIOS, go to the Graphics section and change the “Active LFP” setting to “No LVDS.”
8. Change the “Power Loss Control” setting to “Turn On” (or the setting that is appropriate for your application environment).
9. Press the F10 key to save your settings and exit.